Re: what are my options?

Posted by dr.sportster on March 17, 2005 at 08:22:29 from (209.247.222.112):

In Reply to: what are my options? posted by haymeadow52 on March 16, 2005 at 22:53:33:

The sears Craftsman type Dremel for 1/8" shaft has a couple shapes that work ok[ solid carbide].I ate up a broken 3/8 stud and extractor snapped in hole like this but went over a little and had to heli -coil the mess anyhow.I think 1/4" shaft bits will be a greater chance of thread damage.Oh, they are seven bucks each takes about two but are still usable after.Think Dentistry.

Follow Ups:

• Re: what are my options? dr.sportster 08:31:46 03/17/05 (1)
  • Re: what are my options? Andy Martin 09:14:12 03/17/05 (0)

Post a Followup Name: E-Mail: Hide: Yes No Hiding your address protects you from spam generators but allows you to receive email response notifications. Subject: Comments: Optional Link URL: Link Title: Optional Image URL: Email Notification: If you check this box, email will be sent to you whenever someone replies to this message. Your email address must be entered above to receive notification. This notification will be cancelled automatically after 2 weeks.

TRACTOR PARTS	TRACTOR MANUALS

We sell tractor parts!  We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]