Farmall & IHC Tractors Discussion Board |
Re: w-4 value/use
[ Expand ] [ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by EricB on March 14, 2005 at 04:33:45 from (216.209.84.11):
In Reply to: w-4 value/use posted by Kevin on March 13, 2005 at 19:04:22:
Kevin: Jeff needs to check his engine compresion! I have a W4 with compression about 100 on all 4. Twice last fall I brought 2 wagons in tandam, 4 miles with 110 small squares on each. Took a bit of shifting to get rolling but after that it pulled just fine. Mine is 1942, rebuilt the engine 20 years ago. Use it almost every day in the summer.
Follow Ups:
Home
| Forums
Today's Featured Article -
The Nuts and Bolts of Fasteners - Part 2 - by Curtis Von Fange. In our previous article we discussed capscrews, bolts, and nuts along with their relative hardness and thread sizes. In this segment we will finish up on our fasteners and then work with ways to keep them from loosening up in the field. Capscrews, bolts and nuts are not the only means of holding two parts together. When dealing with thinner metals like sheet tin, a long bolt and
... [Read Article]
Latest Ad:
18-32 Case Cross Motor
[More Ads]
Copyright © 1997-2025 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|