Sleeve pulling update

Posted by Gordo on March 09, 2005 at 07:37:57 from (64.68.166.234):

They're out. Borrowed the IH puck from local dealer. It was marked "H-3 3/8" on the side. Fabricated my own rod from grade 8 continuous and a 1 1/4 cold rolled bar for the top. Wheel lug nut to turn it down. Several oak spacers cut lengthwise on band saw.
Everything in place, 3/4 inch breaker bar and socket and I was prepared to grunt and groan. But to my surprise, after about 540 degrees of moderate torque, they just popped loose and I spun them up with a 12 inch crescent.
Wondering now if they came out "too easy" Guess I will see what shape block bore is in when I start inspalling new sleeves. I can't find a spec sheet on the exact diameter of the bore shoud be.
An H , engine cast in 49.

Follow Ups:

• Re: Sleeve pulling update captaink 08:26:47 03/10/05 (0)
• Re: Sleeve pulling update Gordo 17:21:14 03/09/05 (1)
  • Re: Sleeve pulling update greywynd 23:24:39 03/09/05 (0)
• Re: Sleeve pulling update Andy Martin 12:30:21 03/09/05 (0)
• Re: Sleeve pulling update El Toro 09:23:50 03/09/05 (0)

Post a Followup Name: E-Mail: Hide: Yes No Hiding your address protects you from spam generators but allows you to receive email response notifications. Subject: Comments: Optional Link URL: Link Title: Optional Image URL: Email Notification: If you check this box, email will be sent to you whenever someone replies to this message. Your email address must be entered above to receive notification. This notification will be cancelled automatically after 2 weeks.

TRACTOR PARTS	TRACTOR MANUALS

We sell tractor parts!  We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]