Farmall & IHC Tractors Discussion Board |
Re: Question about new Super M
[ Expand ] [ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by captaink on March 08, 2005 at 10:53:37 from (66.115.214.56):
In Reply to: Question about new Super M posted by Matt - Utah on March 08, 2005 at 09:43:48:
Anytime a tractor (or anything that moves) is not operated on a level surface, concern about tipping over is justified because the steeper the slope the easier it is to tip something over. Operational techniques that will help prevent disaster must be implemented, but will not guarantee an upset will not happen. I can not stress enough that operating tractors on slopes is dangerous and the operator must be knowledgeable about the laws of physics and extremely careful. Even then accidents happen, please don’t be in one of them. Now, to answer your question, compared to driving forward up a slope, backing up a slope will help prevent end over end tipping for two reasons. First the power wheels will be higher up the slope, pulling you up the hill rather than pushing. The rotational "equal but opposite" force will be adding weight to the front end (lower than the rear end) of the tractor rather than trying to lift it up. When backing you will loose traction on the driving (pulling) wheels before there will be enough gravitational force to raise the rear end off the ground. A front pull plate can be attached to the front of a tractor with a narrow front, or you can fabricate one that will bolt on the frame. Either of these will be a hitch point to pull from. Backing so that you are going straight up the incline will help prevent tipping sideways. Lowering the pulling point on the tractor will also lower the “center of gravity” allowing the tractor to be more stable. Widening the rear wheels to the ends of the axles and adding weights will also add to the tractors stability against tipping over sideways. BE CAREFUL! Think about how gravity will be working on the tractor on that slope by walking on it and carrying a 10 lb bag of sugar on your back. Walk up the hill forwards (you will need to lean ahead) and then back up the hill to get a better understanding of the forces on the tractor.
Follow Ups:
Home
| Forums
Today's Featured Article -
Talk of the Town: What's in Your Tractor's Toolbox? - by Staff. This recent discussion on the Tractor Talk discussion board here at the on-line magazine drew so much response and proved to be so interesting that we wanted to share it with you here. The names of the people participating in the discussion have been left out to "protect the innocent" (to quote a once-popular television series).
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
Copyright © 1997-2025 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|