|
Farmall & IHC Tractors Discussion Board |
Re: Frozen Steering on Farmall 856
[ Expand ] [ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Chuck's Repair on March 07, 2005 at 16:49:47 from (216.170.58.10):
In Reply to: Frozen Steering on Farmall 856 posted by PJ@Ohio on March 07, 2005 at 06:50:47:
I had the same problem once.There was water accumulated in the steering cylinder that didn't reserculate back to the sump.Every time the temperature droped below freezing the cylinder would freeze up.This can be easilly checked by teeing a hydraulic gauge in one of the steering lines and leting it set outside over nite.If the pressure climbs to 2200 PSI when you turn the steering wheel and the front wheels don't turn you know there is a block of ice in the cylinder or steering gear.To fix you will have to remove the radiator and remove the top cover on the front bolester and remove the large nut on the steering gear and lower it out the bottom to remove the water.
Follow Ups:
Home
| Forums
| Order Support
Today's Featured Article -
Measuring with Calipers - by Staff. The legs of inside calipers are curved outward at the extremities to facilitate measuring small holes, while outside caliper legs have a large curve inward to increase their capacity for large work. Firm-joint calipers are adjusted approximately by the hands and then set to the feel of the work by tapping them on a metal surface. It is a common practice when opening calipers by this means to tap the top of the joint. It is better, if possible, to tap the inside of the legs, as repeated blo
... [Read Article]
Latest Ad:
Late 50s early 60s international harvester 560 with cultivator
[More Ads]
Copyright © 1997-2026 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|