Farmall & IHC Tractors Discussion Board |
Re: Antique vs modern?
[ Expand ] [ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by wilko on March 01, 2005 at 20:52:01 from (216.134.161.181):
In Reply to: Antique vs modern? posted by deweed(TX) on March 01, 2005 at 10:14:37:
As far as I'm concerned, anything made starting in the 70's is pretty much modern. Think about it. You get power steering, powershift transmission, air conditioning and heat (if w/ cab). The styling on this era of machine was way better than a piece-o-crap kubota, and hey, bonus, it was made in the USA! Look around for a tight, well-maintained machine and you can have the best of both worlds on a budget.
Follow Ups:
Home
| Forums
Today's Featured Article -
The Nuts and Bolts of Fasteners - Part 2 - by Curtis Von Fange. In our previous article we discussed capscrews, bolts, and nuts along with their relative hardness and thread sizes. In this segment we will finish up on our fasteners and then work with ways to keep them from loosening up in the field. Capscrews, bolts and nuts are not the only means of holding two parts together. When dealing with thinner metals like sheet tin, a long bolt and
... [Read Article]
Latest Ad:
18-32 Case Cross Motor
[More Ads]
Copyright © 1997-2025 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|