Farmall & IHC Tractors Discussion Board |
Re: Tractor Vet/egr-IA, 1466 gear teeth in rear
[ Expand ] [ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by the tractor vet on February 27, 2005 at 07:02:58 from (4.124.70.168):
In Reply to: Tractor Vet/egr-IA, 1466 gear teeth in rear posted by SGT K on February 27, 2005 at 03:55:59:
Oh how well i know about finding what ya don't want to find , Like my personal 1486 the guy told me that all it needed was a new cablefor the T/A just got done disken 800 acres with her good tractor looked it over ran it around no this tractor has a nice cab and i did not here the engine misse or fell it , how could you the clutch sliped so bad that it bearley got on the trailer when i got it home that is when ya start finding all the neat stuff , did the clutch and T/A all gears in the speed trans all new bearings in trans ans rear end new cam shaft rebuilt the whole ft.end new a/c compressor new this new that and all the labor i would have to 35000 out of that one but they JUST GOT DONE DISKEN with it .
Follow Ups:
Home
| Forums
Today's Featured Article -
Tractor Traction - by Chris Pratt. Our first bout with traction problems came when cultivatin with our Massey-Harris Pony. Up till then, this tractor had been running a corn grinder and pulling a trailer. It had new unfilled rear tires and no wheel weights. The garden was already sprouting when we hooked up the mid-mount shovel cultivators to the Pony. The seed bed was soft enough that the rear end would spin and slowly work its way to the downhill side of the gardens slight incline. From this, we learned our lesson sinc
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
Copyright © 1997-2025 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|