|
Farmall & IHC Tractors Discussion Board |
Re: Roadgoing IH Tractors
[ Expand ] [ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Farmallkid From Ont, on February 24, 2005 at 07:39:32 from (209.216.154.98):
In Reply to: Roadgoing IH Tractors posted by PAULIH300 on February 23, 2005 at 18:29:27:
Here in Ontario you need a SMV sign, and some of the bigger tractors have fender light's that go over the duals. I just have a smv on my M, and use hand signal's when i turn. Some people don't care about tractors on the road. I was sreading manure with a 2394 case with a 6 speed jerkomatic transmission, and a 3600gal husky tank. The tractor had mirrors, so before i turned into the drive i would check if there was anyone behind me, one time there was a cop, so i waited intill the cars were done coming on the opposite side of the road, had my turn signal on, looked again the cop didn't move, so i started to turn into the drive, then all of a sudden the cop pulled out and i had to hammer on the brakes cause he almost hit my front tire, I made him drive almost all the way in the gravel, i was proud!. here is a pic of a combine that was traveling at night, Near ottawa Ontario. Itv wasin the country, there was a lady from the city driving at night, she was flyin, see hit the back and the combine rolled. It had Reflective tape, flashing light's, smv sign, and the cop light's. She said she didn't see it. She was either drivin a toyota car or truck, my friend who sent me the pic said he couln'd tell cause it was so wrecked.
Follow Ups:
Home
| Forums
| Order Support
Today's Featured Article -
Torque Wrenches - by Curtis Von Fange. When working with fasteners a torque wrench can play an important role in the correct assembly of critical equipment components. Lets examine in detail some of the reasons for using a torque wrench along with how to correctly use the variety of wrenches available. Applying the proper torque to a fastener accomplishes a number of tasks. First of all correct torque will hold the parts together. This may seem like a trite statement but � think about it for a second. Engineers have designed
... [Read Article]
Latest Ad:
WANTED IH C200 gas engine — complete running motor Wanted complete used IH C200 gas engine in running condition for an International 574 gas tractor. My block has a hole in it and is dead, so a rebuild kit wont do it — need a whole running motor. The C200 also came in the 544 and 674 gas trac
[More Ads]
Copyright © 1997-2026 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|