Farmall & IHC Tractors Discussion Board |
Re: new 6V battery and charging system
[ Expand ] [ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by El Toro on February 23, 2005 at 14:56:17 from (152.163.101.13):
In Reply to: new 6V battery and charging system posted by riverbend on February 23, 2005 at 06:39:21:
I would run the tractor and see if that voltage drops as CNKS has posted. If it doesn't drop you may be better off to replace the regulator. Running the tractor with voltage above 7.5 volts may void your warranty on the battery too. When a battery has a dead cell with specific gravity of 1100-1150, I never had any luck in improving that cell by more charging. I've even replaced the electolyte in the bad cell and it still made no difference. Exide claims their spiral wound batteries will start after sitting for one year. Hal
Follow Ups:
Home
| Forums
Today's Featured Article -
The Nuts and Bolts of Fasteners - Part 2 - by Curtis Von Fange. In our previous article we discussed capscrews, bolts, and nuts along with their relative hardness and thread sizes. In this segment we will finish up on our fasteners and then work with ways to keep them from loosening up in the field. Capscrews, bolts and nuts are not the only means of holding two parts together. When dealing with thinner metals like sheet tin, a long bolt and
... [Read Article]
Latest Ad:
18-32 Case Cross Motor
[More Ads]
Copyright © 1997-2025 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|