|
Farmall & IHC Tractors Discussion Board |
Re: Trike Front Ends
[ Expand ] [ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Sloroll on February 21, 2005 at 10:26:21 from (69.66.146.158):
In Reply to: Trike Front Ends posted by Allan in NE on February 21, 2005 at 08:37:51:
Years ago my tractor training instructor proved to a bunch of us farm kids how a trike (dual fronts not single) would actually not flip to the side on a sidehill as fast as a wide front end. Lemmy try with out his models and fake hill. THe trike allows its pivot point to shift from front wheel to front wheel giving it a shift table of about 16" A wide front tractor shifts its weight initially on the single front pivot allowing the center of gravity to project away fron the tractor and further down the hill. We all argued the praise of wide fronts.. still seems logical; but he time after time showed the widefronts more unstable on a rolling hillside. Regardless, to much weight and a long moment is going to toss any tractor. The mistake wasn't in the design of the tractor but the decisions of the operator. I hope he lived to scratch his head and find a low cg rear bail mover.
Follow Ups:
Home
| Forums
| Order Support
Today's Featured Article -
Product Review - by Staff. When we finally checked out the 3000 PSI North Star, the whole story chaned. This unit was equipped with an 11 HP Honda engine with fuel shutoff, adjustable flow and optional syphon degreaser dispenser. It didn't have a pressure release or electric start to facilitate easy starting but according to the instructions, simply pulling on the trigger while cranking was sufficient. This method of starting proved more than adequate and kept the cost down on the unit. It had all the important
... [Read Article]
Latest Ad:
1958 FORD RARE 4x4 801 TRACTOR, ELENCO/FRONT DRIVE, FRONTLOADER AND WEIGHTED REAR WHEELS, FIVE SPEED, LIVE PTO, GAS ENGINE, NEW REAR WHEELS AND TIRES, ENGINE RUNS.
[More Ads]
Copyright © 1997-2026 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|