|
Farmall & IHC Tractors Discussion Board |
Re: O/T Bad Computer Luck
[ Expand ] [ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Ron in Nebr on February 19, 2005 at 19:08:02 from (65.169.97.26):
In Reply to: Re: O/T Bad Computer Luck posted by Kevin in Va on February 19, 2005 at 18:16:03:
Wow...I can follow along with any thread talking about mechanical aspects of tractors, but the stuff you folks are discussing here is way above my head...except the part about the drive heating up when it runs...sounds like some baling twine has wrapped around the axle and taken out the seal and let the grease run out of the bearing or some such.... Seriously though, since the REAL purpose of this board is to let folks use their computers to talk about tractors, I enjoy learing about the computer aspect here almost as much as the tractor part. Good luck to ya Allen, hope you get things up and humming along in no time.
Follow Ups:
Home
| Forums
| Order Support
Today's Featured Article -
Measuring with Calipers - by Staff. The legs of inside calipers are curved outward at the extremities to facilitate measuring small holes, while outside caliper legs have a large curve inward to increase their capacity for large work. Firm-joint calipers are adjusted approximately by the hands and then set to the feel of the work by tapping them on a metal surface. It is a common practice when opening calipers by this means to tap the top of the joint. It is better, if possible, to tap the inside of the legs, as repeated blo
... [Read Article]
Latest Ad:
Late 50s early 60s international harvester 560 with cultivator
[More Ads]
Copyright © 1997-2026 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|