Farmall & IHC Tractors Discussion Board |
no oil presure...cub o/h
[ Expand ] [ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by scruffy on February 03, 2005 at 13:08:45 from (64.228.102.169):
Just gave my cub a pull down the road with the H after an engine over-haul (been seized up, frozen and given up on by more than one owner). Started right up, sounded good, but no oil presure on gauge. Pulled the gauge, no oil behind in filter chamber. Filled up the filter and added extra to well over full. Still no pumping. I havn't dropped the pan yet. I think the suction pipe is tight and sound and know the screen is clean. Are they sometimes difficult to get primed and started? The job to check the pump is absolutly scary! Split required. Before I get the energy to go back at her I thought I'd check with ya-all.
Follow Ups:
Home
| Forums
Today's Featured Article -
Memories of an IH Super A When I was ? up to 10, I worked on my Papaw's farm in Greeneville, TN every summer. As I grew older (7), it was the thrill of my day to ride or drive on the tractor. My Papaw had a 1954 IH Super A that he bought to replace a Cub. My Papaw raised "baccer" (tobacco) and corn with the Super A, but the fondest memory was of the sawmill. He owned a small sawmill for sawing "baccer" sticks. The Super A was the powerplant. When I was old enough (7 or 8), I would get up early and be dressed to
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|