|
Farmall & IHC Tractors Discussion Board |
Re: Single-Point Hitch/Turning Plow Questions
[ Expand ] [ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Hugh MacKay on February 02, 2005 at 13:01:00 from (64.228.11.112):
In Reply to: Single-Point Hitch/Turning Plow Questions posted by Bill in NC on February 02, 2005 at 06:31:16:
Bill: Do you by any chance know the model number of your plow? I guess I'm just wanting to satisfy my own curiosity on that one. My first question what is the wheel tread setting on tractor, center to center on rear wheels. I find my plow gives optimum performance at 52" tread setting. I can make 56" work, but it is a bit of a chalange. I have never tried 48". Is the levelling screw on the left side of hitch? I've seen a few of those get changed to right side of hitch, just will not work. Sounds to me as though your levelling crank, and on the left must be lengtened. One other item you will find with those little plows, points will wear down to a certain point, and that is it. From there it just seems as though that right front moldboard will ride the left rear moldboard right out of soil. It seem as though the more you lower the depth control the worse this situation becomes. It is rather frustrating as I have seen trailer plows with same moldboard and point, that would plow well with more wear. One thing I quite often do is weld truck spring on top of point tip. I weld this parallel with line of travel, extend it back and up point 6", thus allowing 4 to 5 inches to protrude past end of point. This tends to replace point, thus giving plow more suck. I find you can only do this once with each set of points as the share portion is worn by then.
Follow Ups:
Home
| Forums
| Order Support
Today's Featured Article -
Converting from 6 Volt to 12 Volt - by Chris Pratt. It's a common problem for old machines especially when the weather starts to dip below 40 and the tractor isn't fired up as often. You are probably used to the 12 volt Diehard, charged with 200 amp alternator of your 3/4 ton that always is ready and always starts. It's this type of experience that brings about the many queries we get for 12-volt conversion kits. Since only a few kits are available (we sell kits for the
... [Read Article]
Latest Ad:
Late 50s early 60s international harvester 560 with cultivator
[More Ads]
Copyright © 1997-2026 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|