Farmall & IHC Tractors Discussion Board |
Re: Super C Hydraulic rebuild
[ Expand ] [ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by scott#2 on February 02, 2005 at 12:49:09 from (138.88.82.92):
In Reply to: Super C Hydraulic rebuild posted by Dandy Don on February 01, 2005 at 19:26:31:
I just finished a touch control block on a super a and was very hesitant at first after seeing the exploded view. I dont know if its any where close to the sc unit or not. First thing is pressure wash the block and area real good and then remove the unit from the tractor. Clean the unit real good again after its removed. When you disassemble it, have a place where you can lay all the parts in the order they came out so they go back in the same place and order they came from. Keep everything CLEAN, CLEAN, CLEAN!!! or make it so. After I cleaned the block real good and blew it out, I then felt all over for burrs and scars and smoothed anything rough down with a stone. Get a manual or a copy of the exploded view from the dealer parts book but still pay close attention to how it comes apart as sometimes the manual leaves a little to be desired. Take pictures if need be. When you reassemble it, do one part at a time and double check it. Everything should move smoothly. Be carefull with the installation of the new o-rings, roll them on or in place if possible and use hyd. fluid on the reassembly. Use light grease to hold parts in place if needed. Rool or twist the parts with o-rings back into the bores as not to tear the new o-rings up. It looks difficult but I would say the hardest part is getting started on it. There are many guys on this forum that helped me do mine and if I can do it, believe me, anyone can. Hope this helps and post back if you need any help. scott#2
Follow Ups:
Home
| Forums
Today's Featured Article -
Ford Part Number Trivia - by Forum Participants. "Replaced by" means the part was superseded. All of my part books date back to 1964 and New Holland have changed some part numbers. They usually put the old Ford part number on the package. I was suppressed when I looked up the part number of the auxiliary drive shaft because for some reason the part number went through a radical change and it lost its "Basic Part Number". Ford part numbers follow the following rules. Most part numbers are in three parts. The middle part is called the
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|