|
Farmall & IHC Tractors Discussion Board |
Re: 3 Super C Questions
[ Expand ] [ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Hugh MacKay on January 14, 2005 at 03:46:30 from (216.208.58.118):
In Reply to: 3 Super C Questions posted by terryj on January 13, 2005 at 20:06:32:
terry: You have very good advice from FC and TDK, so no point in me repeating all of that. My only point is one should never leave any hydraulically raised equipment in the raised position. It will prematurely cause damage to system, plus it's a bit dangerous. I set my blade on two 6"x6" wooden blocks. Not for the reason you are suggesting as my shop is not connected to house. One just never knows when he may wish to tow the tractor out through the door. Our tractors are 50 years old by now.
Follow Ups:
Home
| Forums
| Order Support
Today's Featured Article -
Tractor Profile: Ford 600 Series - by Staff. The Ford 600 Series tractors bean production in 1954, and continued until 1957. Quite similar to the Ford NAA (Golden Jubilee) in design, it used the same 132 cubic inch Red Tiger engine with 31 horsepower. Several different models were made in the 600 Series, and these numbers were used to denote whether they used a particular transmission, hydraulic system, or PTO. The result was five different model numbers: 620, 630, 640, 650 and 660. These break down as follows:
... [Read Article]
Latest Ad:
For sale Farmall super A tractor is complete and has just been setting for awhile,it was running when pulled out of the barn,shouldn’t take to much to get it going asking 1100.00
[More Ads]
Copyright © 1997-2026 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|