H axle widths

Posted by John in Ne. on January 10, 2005 at 16:17:19 from (65.161.103.185):

Earlier today I got into the middle of a thread and stated that there are three differnt H's in my shop with three differnt axle widths.When I got home today I looked in the manual and it only listed 2,one is 88inches and one is 100 inches.Thinking I had lost my mind,I went out and measured them. ser#79690-100 inches,ser#391586-88 inches and ser#285394-80 inches.The last one is mine,and it does not looked like it has been cut off or altered.If it has,it was done in a lathe as it even has the center hole in it.I shortened the axles on my C a couple of years ago with a band saw because someone in the past had done it with a torch and it looked like ,,bad. Anyway,maybe someone could shed some light on this. John.

Follow Ups:

• Re: H axle widths CNKS 18:32:16 01/10/05 (0)

Post a Followup Name: E-Mail: Subject: Comments: Optional Link URL: Link Title: Optional Image URL: Email Notification: If you check this box, email will be sent to you whenever someone replies to this message. Your email address must be entered above to receive notification. This notification will be cancelled automatically after 2 weeks.

TRACTOR PARTS	TRACTOR MANUALS

We sell tractor parts!  We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]