Farmall & IHC Tractors Discussion Board |
Re: Farmall C camshaft reality
[ Expand ] [ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Opa A on January 07, 2005 at 09:57:13 from (161.184.42.253):
In Reply to: Re: Farmall C camshaft reality posted by j a nicholson on January 07, 2005 at 07:07:10:
Since you don't yet have the rocker shaft fastened down it would be very easy to check lifter travel. Crank the engine over by hand and measure pushrod travel with a dial indicator, should be the same as the lobe rise you measured on the camshaft before installing it. If lobe rise is not known, check from lobe to lobe for consistent measurements.
Follow Ups:
Home
| Forums
Today's Featured Article -
Updatin The Charging System of Your Older Tractor - by Tyler Woods. Older tractors have externally regulated generators or externally regulated alternators, in some instances. That means there is one device that turns energy from the fan belt into electrical energy,
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|