|
Farmall & IHC Tractors Discussion Board |
Re: help with 12 volt conversion
[ Expand ] [ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by jeff smith on January 04, 2005 at 16:25:34 from (198.89.66.135):
In Reply to: Re: help with 12 volt conversion posted by farmallhal on January 04, 2005 at 13:16:41:
I had the #2 pin back to the battery terminal just like the diagram. The #1 runs to the ignition. The hot wire is to the + on the coil and (-) to the dist. Could my ammeter be bad? The glass is cracked a little. I really did follow the diagram you speak of and it was not charging. I can switch out the light for the resistor. An article I read said the light would go out when it was charging so I liked that idea, I certainly can switch that out. I get the pins mixed up when talking about them but I had the diagram outside with me and double checked everything. I think I am going to have to pull out the ignition and wire it again or replace it. Is there a way to test the ammeter and find out if it is working. I would think it was since the tractor starts
Follow Ups:
Home
| Forums
| Order Support
Today's Featured Article -
Pop's Tractor of Gold - by Gary Teate. My father was a simple man but could repair just about anythin mechanical that was ever made. From the time I was a young boy growing up in Jacksonville, Florida, I would spend a considerable amount of time helping my father repair or rebuild equipment and engines, etc. on our 2 1/2 acre "spread". Pop always dreamed of having more acreage out in the country where he could retire and tinker as much as he wanted and often reminisced about his boyhood days on his grandfathers farm in Montecello,
... [Read Article]
Latest Ad:
1952John Deere MT tractor
[More Ads]
Copyright © 1997-2026 Yesterday's Tractor Co.
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|
