Re: Super C Brake Grabs

Posted by Farmer Bob on January 01, 2005 at 12:33:14 from (67.5.114.155):

In Reply to: Super C Brake Grabs posted by BUD W on January 01, 2005 at 11:06:03:

Bud, Sounds like you have a ball hanging up in the actuator plate, (I assume the Super C has disk brakes). Between the two halfs of the actuator plates there should be steel balls that ride in egg shaped divots. These have to be smooth and the balls should be shiny and smooth as well. If there are ridges in either the ramps or the balls, clean them up and/or replace the balls. I use a light coating of lithium grease on the balls when I redo these brakes. There is also a chance that the surfaces that the brake pads hit when you apply the brakes are rough. These, whether the outer surfaces of the actuators or the housings, can be cleaned up at most brake/machine shops. Post back what you find.

Follow Ups:

• Re: Super C Brake Grabs BUD W 14:14:22 01/01/05 (0)

Post a Followup Name: E-Mail: Subject: Comments: Optional Link URL: Link Title: Optional Image URL: Email Notification: If you check this box, email will be sent to you whenever someone replies to this message. Your email address must be entered above to receive notification. This notification will be cancelled automatically after 2 weeks.

TRACTOR PARTS	TRACTOR MANUALS

We sell tractor parts!  We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]