Farmall & IHC Tractors Discussion Board |
Re: Getting more horse power out of a M
[ Expand ] [ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by RustyFarmall on December 30, 2004 at 07:27:30 from (216.248.75.145):
In Reply to: Getting more horse power out of a M posted by Darrell Wilson in West K on December 30, 2004 at 07:08:48:
I would imagine that by now the old girl has already been equipped with the 4 inch overbore kit so we can rule that out, unless it's time for a rebuild anyhow. The next thing is to make sure that everything is in good tune, plugs, points, timing, plug wires, and all that stuff, which you probably already knew. One thing that can make a big difference is the valves, if the M hasn't had the valves reground in a while, you are losing horsepower. Also, make sure the valve clearance is correct. One other thing I will mention is the governor, make sure it is operating properly and giving the full rated RPM, a sluggish governor will really hurt performance. You can even "tweak" the gov a bit to give it a few more RPMs, within reason, more speed will not hurt the engine.
Follow Ups:
Home
| Forums
Today's Featured Article -
An Old-Time Tractor Demonstration - by Kim Pratt. Sam was born in rural Kansas in 1926. His dad was a hard-working farmer and the children worked hard everyday to help ends meet. In the rural area he grew up in, the highlight of the week was Saturday when many people took a break from their work to go to town. It was on one such Saturday in the early 1940's when Sam was 16 years old that he ended up in Dennison, Kansas to watch a demonstration of a new tractor being put on by a local dealer. It was an Allis-Chalmers tractor dealership,
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|