Farmall & IHC Tractors Discussion Board |
Re: 2001 loader
[ Expand ] [ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Weldon on December 24, 2004 at 08:14:27 from (166.102.61.144):
In Reply to: 2001 loader posted by Scotty mn on December 23, 2004 at 04:12:52:
Scotty, I have a 2001 loader on an International 504 (utility model). It has the factory equipped, single hydraulic cylinder, dump bucket. I have the operator's manual for it and also a sales brochure with good photos. I am willing to send you images of pages from these by either e-mail or paper copies by US Mail.Reply through this ytmag site if interested. Show your e-mail address and I can contact you directly. As for your loader transfering from a 560 to a super M , Operator manual shows different front mounting brackets, also a different attachment system for clamping the sub-frame to the rear axles. So , in a word, no , it will not transfer directly to a super M with out some cutting and fabricating some 'make it work'' parts. Hope this helps. Weldon
Follow Ups:
Home
| Forums
Today's Featured Article -
Memories of an IH Super A When I was ? up to 10, I worked on my Papaw's farm in Greeneville, TN every summer. As I grew older (7), it was the thrill of my day to ride or drive on the tractor. My Papaw had a 1954 IH Super A that he bought to replace a Cub. My Papaw raised "baccer" (tobacco) and corn with the Super A, but the fondest memory was of the sawmill. He owned a small sawmill for sawing "baccer" sticks. The Super A was the powerplant. When I was old enough (7 or 8), I would get up early and be dressed to
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|