|
Farmall & IHC Tractors Discussion Board |
Re: 800 hp tractor on YT home page
[ Expand ] [ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by farmallkid From ONT. on December 18, 2004 at 07:11:40 from (209.216.154.136):
In Reply to: 800 hp tractor on YT home page posted by Hugh MacKay on December 17, 2004 at 13:12:22:
Hi hugh, could'nt find it, it is probably off the page. it is 10:00 saturday morning as i'm typing. There was an atricle in the ontario farmer about this tractor, from what i remember, he bought a big cat dozer, the engine was seized, and there was bullet holes all over it, causer it was in the war. I think he shipped it over seas to. This tractor was made around cobourg ontario, we went to ottawa in the spring, and when we were on the highway heading back, we were coming through cobourg, and on the right side of the road there it was, it was massive, i think he was cultivating, Usualy i can tell from a mile away what kind of tractor is coming, but this one i didn't recognize. I think it had triples all the way around. Mitch
Follow Ups:
Home
| Forums
| Order Support
Today's Featured Article -
Massey Ferguson 35 (and up) Tractor Assembly Notes - by Jack Wetmore. These assembly notes are for Massey Ferguson tractors with a two stage clutch and 6 speed, 8 speed and mutli-power transmissions. I see a lot of discussion forum messages regarding damaged clutches from improper assembly. The objective is to have the engine and transmission slide together safely and easily until the gap between the two halves is less than 1/4", BEFORE tightening any of the bolts holding the two together. Using bolts to draw the two halves together will damage the PTO
... [Read Article]
Latest Ad:
1 SD Gibson, 1 D Model needs rear end assembled and installed, 1 D Model needs minor repairs, extra parts
[More Ads]
Copyright © 1997-2026 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|