|
Farmall & IHC Tractors Discussion Board |
Re: Tire spins on right side of Farmall 100 when w
[ Expand ] [ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Novel Idea Guy on December 17, 2004 at 08:39:14 from (64.80.110.33):
In Reply to: Re: Tire spins on right side of Farmall 100 when w posted by Ramon from NC on December 17, 2004 at 06:57:27:
Be careful blindly following some of the advice you get. Some of it is just plain silly, some is downright foolish, and some is just plain dangerous. First off, make sure your tractor is set up properly. You seem to have completely ignored the recommendations to make sure your tractor has the correct wheels on the correct sides. Go back and do that, or you could end up with the tractor riding YOU instead of you riding the tractor... Now, the way a differential works is that the wheel with the least traction always spins first. If it's always the right wheel, then there is a reason for that: The right rear tire could be more worn than the left, or of a poorer design. If the tires aren't matched, then this is probably the reason. The surface conditions might give you less traction under the right wheel. Sandy/slick/wet dirt under the right vs. hard dry under the left. The tractor is light on the right side. Make sure the cast wheel center is on the right side!!! Weighing down the tractor with reckless abandon is not the answer. When you're moving dirt, scraping, pushing, digging, plowing, YOU WANT THE TRACTOR TO SPIN!!! If wheels don't spin, something will break. If you're not getting anything done, then add weight, within reason. Don't exceed the number of wheel weights as recommended in the owner's manual, and even then that may be too much. Add weight gradually, until you can do the job, then stop. Use common sense.
Follow Ups:
Home
| Forums
| Order Support
Today's Featured Article -
Memories of a Farmall C - by Monty Bradley. When I was a child, my grandparents lived on a farm owned by a Mr. Walters. The crops raised were cotton and soybeans, with about forty head of mixed breed cattle. Mr. Walters owned two tractors then. A Farmall 300 on gasoline and a Farmall C, that had once belonged to his father-in-law, and had been converted from gasoline to LP Gas. Many times, as a small boy, I would cross the fence behind the house my grandparents lived in and walk down the turn row to where granddaddy would be cultivati
... [Read Article]
Latest Ad:
1958 FORD RARE 4x4 801 TRACTOR, ELENCO/FRONT DRIVE, FRONTLOADER AND WEIGHTED REAR WHEELS, FIVE SPEED, LIVE PTO, GAS ENGINE, NEW REAR WHEELS AND TIRES, ENGINE RUNS.
[More Ads]
Copyright © 1997-2026 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|