Farmall & IHC Tractors Discussion Board |
Re: Tough PTO coupler removal and Replacing PTOsha
[ Expand ] [ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Andy Martin on December 14, 2004 at 12:42:23 from (64.219.39.195):
In Reply to: Tough PTO coupler removal and Replacing PTOshaft posted by Ramon from NC on December 14, 2004 at 07:41:24:
Clean each piece off real good and slide the implement piece on slowly. When it gets in a bind, carefully look to see where it is binding and file the spot that is rubbing. Usually the piece on the tractor has damage. Many times it is just a high spot from the quick release shaft wollowing out it's groove and leaving a high spot. If it goes almost all the way on look at the ends of the grooves on the tractor. This problem is common and not hard to fix, it just takes a little patience and you have to study it a little. It is a lot easier to fix than replace.
Follow Ups:
Home
| Forums
Today's Featured Article -
Gatherin of the Orange - by Rick Nikolich. In July of 1998 I was talking to fellow Allis Chalmers collector Mike Schilling about the annual "Gathering of The Orange" AC show coming up in August of 1999. He got this wild idea that we should get a convoy of AC tractors and drive them from Charlotte, Michigan 105 miles to LaGrange, Indiana.
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|