Re: water in oil IH 674

Posted by Ian Davies on December 09, 2004 at 13:15:13 from (219.88.46.71):

In Reply to: Re: water in oil IH 674 posted by Yellott Canby on December 09, 2004 at 07:19:03:

The D-239 in the 674 is a wet sleeve, From IT book No IH-44
" THe wet sleeves should be removed when out of round or taper exceeds .006 inch. Cylinder sleeves can be removed by bumping them from the bottom with a block of wood. Before installing new sleeves thoroughly clean counterbore at top and seal ring groove at bottom. all sleeves should be free to rotate by hand when tried in bores without seal rings"

I may have to do a top engine overhaul to because of burning oil. To kill two birds with one stone how can I increase power at the same time ? Stroking, higher compression pistons etc

Follow Ups:

Post a Followup Name: E-Mail: Subject: Comments: Optional Link URL: Link Title: Optional Image URL: Email Notification: If you check this box, email will be sent to you whenever someone replies to this message. Your email address must be entered above to receive notification. This notification will be cancelled automatically after 2 weeks.

TRACTOR PARTS	TRACTOR MANUALS

We sell tractor parts!  We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]