Re: sizing sleeves + pistons

Posted by ChadS on December 04, 2004 at 07:36:30 from (66.228.96.184):

In Reply to: sizing sleeves + pistons posted by Brian Robbins on December 03, 2004 at 13:32:28:

Ok, either way, its all gonna cost about the same for the kits. Go with a Super H-300 sleeve and piston kit. it is the 3-9/16 bore kit. and the bigger displace ment over the original super H cubic inch. this sleeve kit will go into your H block, all it really is,,,, a bored out H sleeve and piston kit. will make you a good 39-42 HP with the small carb, old cyl head, and H cam. Now,, I do belive you have a 3-7/16 bore size!! Gentleman,, that was the IH overbore kit for the H, and standard equipment for the first Super H's!! your H at some point, has had a rebuild, and this kit installed. so really, you have 164 cubic inches, not 152. Now,, there is a kit for the Super H, that was the overbore that is 3-1/2, which was not listed in the IH books as a standard displacement option from the factory, you could order it, and have it installed. 3-1/2 was not the factory bore for the Super H, it was 3-7/16. All before 1953! the cubic in listings are C152, (3-3/8bore) C-164 (3-7/16 bore) C-169 (3-9/16bore) and the C-175 (3-5/8bore) Notice, one is missing,,, the 3.5 bore kit,,,, because, that was the overbore kit option. Hope this helps. if you need some specs, email me,, would be happy to give info on what you need. ChadS

Follow Ups:

Post a Followup Name: E-Mail: Subject: Comments: Optional Link URL: Link Title: Optional Image URL: Email Notification: If you check this box, email will be sent to you whenever someone replies to this message. Your email address must be entered above to receive notification. This notification will be cancelled automatically after 2 weeks.

TRACTOR PARTS	TRACTOR MANUALS

We sell tractor parts!  We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]