|
Farmall & IHC Tractors Discussion Board |
Zenith Carb venturi question
[ Expand ] [ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Bobcat on December 01, 2004 at 19:08:29 from (69.66.80.179):
I have a Zenith K-5 carburator that I just can"t seem to get to idle well. It is on a F-30 that has new rings complete reconditioned head new valves, guides, seats. Compression is great. I have the fuel level right according to my manual. have checked with a sight tube. This carb is clean and all jets are free. Tractor does not skip a beat above 1/4 throttle. Also is there a 0-ring around the bottom of the venturi as mine does not have one and the parts manual does"nt show one? The idle screw does seem to effect the speed but will not clean up the rough idle. I have had this apart more times than I would like to admit to! I have the valves set at .017 plugs at .020 and the points are at .013.
Does anyone have any ideas to try?
Follow Ups:
Home
| Forums
Today's Featured Article -
Tractor Traction - by Chris Pratt. Our first bout with traction problems came when cultivatin with our Massey-Harris Pony. Up till then, this tractor had been running a corn grinder and pulling a trailer. It had new unfilled rear tires and no wheel weights. The garden was already sprouting when we hooked up the mid-mount shovel cultivators to the Pony. The seed bed was soft enough that the rear end would spin and slowly work its way to the downhill side of the gardens slight incline. From this, we learned our lesson sinc
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
Copyright © 1997-2025 Yesterday's Tractor Co.
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|
