|
Farmall & IHC Tractors Discussion Board |
Re: What's with all this 2-point stuff?
[ Expand ] [ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by steveormary on November 27, 2004 at 10:04:30 from (216.31.91.199):
In Reply to: Re: What's with all this 2-point stuff? posted by sammy the RED on November 26, 2004 at 22:34:11:
So by semi mount you mean that the plow has two arms that snap into the lift arms on the tractor. Then you have either a mechanical or hydraulic lift assist system to put down pressure on the tail wheel of the plow to help support the plow for transport. You are right about the Fast Hitch not being fast. I had to back my plow against a tree to get the lift arms to snap in and chain it to the tree when unhitching. But it was a good plow model 514? 4-16"s steveormary
Follow Ups:
Home
| Forums
| Order Support
Today's Featured Article -
Massey Ferguson 35 (and up) Tractor Assembly Notes - by Jack Wetmore. These assembly notes are for Massey Ferguson tractors with a two stage clutch and 6 speed, 8 speed and mutli-power transmissions. I see a lot of discussion forum messages regarding damaged clutches from improper assembly. The objective is to have the engine and transmission slide together safely and easily until the gap between the two halves is less than 1/4", BEFORE tightening any of the bolts holding the two together. Using bolts to draw the two halves together will damage the PTO
... [Read Article]
Latest Ad:
1 SD Gibson, 1 D Model needs rear end assembled and installed, 1 D Model needs minor repairs, extra parts
[More Ads]
Copyright © 1997-2026 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|