|
Farmall & IHC Tractors Discussion Board |
Re: PTO Shaft Seal Interchange???
[ Expand ] [ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Okie Dave on October 27, 2004 at 15:00:15 from (152.163.101.13):
In Reply to: Re: PTO Shaft Seal Interchange??? posted by Haas more info on October 24, 2004 at 03:18:11:
Ok I had napa cross reference the seal numbers you gave me and they all came back to the same seal as far as napa has, I went ahead and got it and low and behold I drained the tractor and removed the old seal and they arn't the same, it's the right size but the one in the tractor is twice as as thick and has a rubber seal and a felt wiper in it, the one i got from napa is just a single rubber seal, back to square one except now I have the tractor disabled, took the seal that came out of the tractor to napa and they couldn't match it now what, put two of thier seals in back to back, now i'm in a bind.
Follow Ups:
Home
| Forums
Today's Featured Article -
The Nuts and Bolts of Fasteners - Part 2 - by Curtis Von Fange. In our previous article we discussed capscrews, bolts, and nuts along with their relative hardness and thread sizes. In this segment we will finish up on our fasteners and then work with ways to keep them from loosening up in the field. Capscrews, bolts and nuts are not the only means of holding two parts together. When dealing with thinner metals like sheet tin, a long bolt and
... [Read Article]
Latest Ad:
18-32 Case Cross Motor
[More Ads]
Copyright © 1997-2025 Yesterday's Tractor Co.
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|
