Re: hydraulic level on a 240 w/ loader

Posted by Dave D on October 23, 2004 at 05:38:01 from (4.233.173.3):

In Reply to: Re: hydraulic level on a 240 w/ loader posted by K.B.-826 on October 22, 2004 at 18:05:52:

K.B., thanks again for your advice. I'll continue the hunt for
that dipstick (my wife says I don't have to look far) as soon
as the frost lifts outside. My 5 gals trans fluid is already
fresh & clean, courtesy of my axle gasket replacement
project 3 wks ago. Haven't noticed the other plugs you
identify but I will pay closer attention. The rusty coupling
trick sounds logical but I am nervous about cutting into a
functioning hose. In this case the hose terminates in a
female fitting which appears to be integrated into one of
the loader arms. It's mostly inside the arm.

Follow Ups:

Post a Followup Name: E-Mail: Subject: Comments: Optional Link URL: Link Title: Optional Image URL: Email Notification: If you check this box, email will be sent to you whenever someone replies to this message. Your email address must be entered above to receive notification. This notification will be cancelled automatically after 2 weeks.

TRACTOR PARTS	TRACTOR MANUALS

We sell tractor parts!  We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]