Farmall & IHC Tractors Discussion Board |
Re: Pacin' the Floor
[ Expand ] [ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by captaink on October 22, 2004 at 09:17:59 from (66.115.214.56):
In Reply to: Pacin' the Floor posted by Allan in NE on October 22, 2004 at 07:15:58:
OK here goes. My M has Behlen power steering on it. My dad put the kit on the tractor in the ‘60’s ‘cause he had a JD picker mounted on it when the loader wasn’t. He made a tank to fit where the belly pump was. I’ 95% sure the pump came as part of the kit. The kit consisted of the pump ahead of the distributor, a priority valve, and hoses. The pump number that you mentioned sounds familiar, but the tractor is now 14 miles away from me at home so I won’t be able to check it for a couple of hours. The pump has two hoses on it one for suction (3/4” I think”) and one outlet (1/2” I think) which goes to the priority valve. From there hoses go to the power steering unit and a double acting valve mounted on a bracket attached to the belt pulley housing. Return lines are tee back into the suction line at the bottom of the tank. If you would like detailed pictures and don’t mind looking at a tractor truly in its working clothes, I can post some later this evening. Either post here or Allen has my e-mail. As far as functionality of the pump, mine works great, and have never regretted the conversion. I have a DuAll loader on it, move round bales weighing up to 1400# and can steer it with one finger if I want. Schwartz wide front with 235 X 16” pickup tires on the front and 15.5 38 tires on 14” 560 wheels on the back and 2 sets of wheel weights (no fluid). The loader is slower than a snail when it’s below 0 F till it warms up, but above that it works fairly fast, but not as fast as a PTO driven pump. Let me know if you want more info or have more questions.
Follow Ups:
Home
| Forums
Today's Featured Article -
Tractor Traction - by Chris Pratt. Our first bout with traction problems came when cultivatin with our Massey-Harris Pony. Up till then, this tractor had been running a corn grinder and pulling a trailer. It had new unfilled rear tires and no wheel weights. The garden was already sprouting when we hooked up the mid-mount shovel cultivators to the Pony. The seed bed was soft enough that the rear end would spin and slowly work its way to the downhill side of the gardens slight incline. From this, we learned our lesson sinc
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
Copyright © 1997-2025 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|