|
Farmall & IHC Tractors Discussion Board |
Super C hydraulics troubleshooting
[ Expand ] [ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by genep on October 19, 2004 at 11:02:33 from (208.148.209.122):
I bought a Super C from a widowed neighbor. It was her late husband's pride and joy. After he died the kid took it to deer camp and brought it back several years later sadly neglected. I've got it running and to my shop, but the hydraulics aren't working. It has oil a couple af inches below the filler plug, but nothing works. Any suggestions on the most simple way to determine if the pump is good or bad? There are all hard lines between the reservoir and the pump. This tractor has the rock shaft above the clutch housing and another valve on the side that operates the fast hitch. My email is open if anyone can get me started. Where is the serial number supposed to be? Thanks much..Gene
Follow Ups:
Home
| Forums
| Order Support
Today's Featured Article -
Two-Brush Generators - by Chris Pratt. Whether for product liability or because the aftermarket parts and labor business is lucrative, this concept is disturbingly prevalent. Fortunately when you step into your shop and make that jump 50 years back in time to work with your old tractor, this concept goes out the window. Even so, when it comes to the charging system, people quickly revert to this idea and start replacing the major components one at a time until it works. The reason you don't find any decals in your replacement set wit
... [Read Article]
Latest Ad:
WANTED IH C200 gas engine — complete running motor Wanted complete used IH C200 gas engine in running condition for an International 574 gas tractor. My block has a hole in it and is dead, so a rebuild kit wont do it — need a whole running motor. The C200 also came in the 544 and 674 gas trac
[More Ads]
Copyright © 1997-2026 Yesterday's Tractor Co.
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|
