|
Farmall & IHC Tractors Discussion Board |
Re: SUPER A with a MOWER
[ Expand ] [ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by can't usemyname on October 19, 2004 at 10:47:58 from (205.188.117.22):
In Reply to: SUPER A with a MOWER posted by BOHEMIANJON on October 19, 2004 at 05:07:06:
I have a Super A with Worksaver brand 3 pt hitch and I use a Bush Hog brand 4 ft mower. Thw PTO shaft clears the A frame OK and the whole set-up works just fine. To lift the mower,I did put on a beefier version of the steel rod that connects the front rockshaft to the rear rockshaft. The standard rod may have been strong enough, but it just didn"t seem strong enough to me. Pete
Follow Ups:
Home
| Forums
| Order Support
Today's Featured Article -
Tractor Profile: Case VA Series - by Staff. V, VC, VI and VO). Althouh the Case VA looked much like the V, it shared no major components with its predecessor. Except for military units, the production of the Case VA was interrupted in July of 1942 due to World War II. It resumed again in 1944 and continued until 1953. It started up briefly later on in 1953 and continued on a very limited basis until 1956. The VA Series included the following models: VA: Fixed front wheel tread VAC:
... [Read Article]
Latest Ad:
Massey Ferguson model 65 diesel tractor
[More Ads]
Copyright © 1997-2026 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|