Posted by ScottyHOMEy on April 03, 2009 at 11:41:33 from (71.241.194.27):
In Reply to: Re: Stud length posted by GaryinAL on April 03, 2009 at 10:22:18:
Thanks, Gary and to Jim Becker, too. Someone having a stud out is what Bob needed to find.
The parts book list the nuts in two places, with the seat box and with the deck. The studs are listed only with the deck, and with the only reference to size and thread pitch being the nuts to hold the box down.
But just as you have observed, it's not unusual to have a coarse thread on one end of a stud and fine on the other. In that case the All-Thread is going to cut it.
Wondering now if there might be an automotive manifold stud that might fit the bill, now that we have better info, even if it is a little long on the fine-threaded side.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - On the Road with Dave Gohl: Tractor Club Beginnings - by Dave Gohl. I was surprised about a month ago when I got a call from a fellow tractor croonie. His message was interesting and to the point. He's says "Dave, I've been thinking about starting a Two Cylinder club for our area. What do ya think?" It was a loaded question. I said that I would be interested, and was wondering what his next step was. (Although I was talking under my breath, since I thought of this some years ago) My friend, Arlyn Lamb of Lakeville, Minnesota was sincere in his miss
... [Read Article]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
