|
Farmall & IHC Tractors Discussion Board |
Re: looking to buy
[ Expand ] [ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by BoydG on October 10, 2004 at 18:12:36 from (208.186.57.65):
In Reply to: looking to buy posted by Ben Rauls on October 10, 2004 at 17:14:46:
Ben It looks like you have a 1950 M. Check the gear shift lever to see if it is sloppy. Should go into gear smothly. Drive it around the lot. Try each gear and listen for any whines or growling in each gear. It should not slip out of gear. Check front end (steering) for extensive looseness. Check the brakes. It would be nice if the tin work was real nice. When you pull the throttle lever back does it have a good and snappy response?
Follow Ups:
Home
| Forums
Today's Featured Article -
The Nuts and Bolts of Fasteners - Part 2 - by Curtis Von Fange. In our previous article we discussed capscrews, bolts, and nuts along with their relative hardness and thread sizes. In this segment we will finish up on our fasteners and then work with ways to keep them from loosening up in the field. Capscrews, bolts and nuts are not the only means of holding two parts together. When dealing with thinner metals like sheet tin, a long bolt and
... [Read Article]
Latest Ad:
18-32 Case Cross Motor
[More Ads]
Copyright © 1997-2025 Yesterday's Tractor Co.
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|
