Re: Hydrolics on 564 series

Posted by cb.ont on October 08, 2004 at 19:59:14 from (216.209.168.90):

In Reply to: Hydrolics on 564 series posted by S.daughtry on October 08, 2004 at 18:16:30:

Check that the Draft Control Level has not been moved to the light draft position.

This happend on our 684 with the mower on it about a mouth ago. I was just going to unhook the mower and it would not going down when the lever for the 3 point hitch was pushed to the lowering position.

This had be stumped for about 20 minutes till I noticed the drarf lever had been moved to light position , when it is usually always left in the heavy position. The draft control lever is right next to the 3 point hitch lift lever.

Good Luck and Make sure all Fingers and Toes are clear and free from danger. Have A safe harvest.
Chris B.

Follow Ups:

• Re: Another note cb.ont 20:12:28 10/08/04 (0)

Post a Followup Name: E-Mail: Subject: Comments: Optional Link URL: Link Title: Optional Image URL: Email Notification: If you check this box, email will be sent to you whenever someone replies to this message. Your email address must be entered above to receive notification. This notification will be cancelled automatically after 2 weeks.

TRACTOR PARTS	TRACTOR MANUALS

We sell tractor parts!  We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]