Cotter Pin questions and How to figure tire size

Posted by Al Fitch on October 07, 2004 at 07:36:03 from (70.18.139.230):

I just started posting here with questions about my 1944 Farmall
A and I have more questions:

I think I know the answer to my cotter pin question but here it
goes:

I found most cotter pins to be placed in the holes of the plow I
attached straight. I am pretty sure I am supposed to bend out
one side after I install them. Is that correct?

When installing my McCormick Deering A91 plow there was info
in the install directions about spacing depending on tire size etc.

Is tire size in this regard how wide the tire is or the diameter of
the tire? Or is it both?

Al Fitch

Follow Ups:

• Re: Cotter Pin questions and How to figure tire si El Toro 14:25:45 10/07/04 (0)
• Re: Cotter Pin questions and How to figure tire si captaink 09:41:49 10/07/04 (0)
• Re: Cotter Pin questions and How to figure tire si sammy the RED 08:06:54 10/07/04 (0)

Post a Followup Name: E-Mail: Subject: Comments: Optional Link URL: Link Title: Optional Image URL: Email Notification: If you check this box, email will be sent to you whenever someone replies to this message. Your email address must be entered above to receive notification. This notification will be cancelled automatically after 2 weeks.

TRACTOR PARTS	TRACTOR MANUALS

We sell tractor parts!  We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]