|
Farmall & IHC Tractors Discussion Board |
Re: best plugs for cub??
[ Expand ] [ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Dr.Evil on October 04, 2004 at 10:17:24 from (216.136.115.250):
In Reply to: Re: best plugs for cub?? posted by George Willer on September 30, 2004 at 07:19:29:
George is correct about heat range. If a plug over-heats the center & side electrodes melt & burn off and the plug stops firing. Not sure on the CUB but most letter series FARMALLS used a D-16 Champion plug when they were worked hard. In the mid 60's Champion came out with a D-15Y plug, cooler heat range but extended tip to get the spark down into the fuel/air mixture and that is what I have in My tired old Super H, and I bet the plugs are 20+yrs old. If You run a VERY hot plug like a D-21 and are pulling the engine hard I would say your over-heating Your plugs and risking SERIOUS DAMAGE to Your engine. Anything from detonation, collapsed ring lands, holes burned in the piston tops, burned valves, etc. It's better to err on the side of a slightly cold plug that way to hot of plug. I've made that mistake in the past and have the repair bills to prove it.
Follow Ups:
Home
| Forums
| Order Support
Today's Featured Article -
Trailering Your Tractor - by Curtis Von Fange. One of the fun things of summer and fall are the parades and tractor shows that go on across America. Many owners of tractors travel long distances to attend these shows and they usually take their restored iron along with them. Safe trailering practices and inspections will ensure that the event is a fun one. A good habit to develop when using a trailer is to give that �quick look over� before taking it on a trip. Before hooking up to it check the tongue for proper operation. The latche
... [Read Article]
Latest Ad:
1965 International Harvester McCormick Farmall cub tractor 2,500. Two owner tractor. My grandfather bought new in 1966, then we inherited it. Have all the paperwork original manual and all maintenance records. It starts and moves. Comes with underbelly mower, plough, and some other attachments.
[More Ads]
Copyright © 1997-2026 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|