Farmall & IHC Tractors Discussion Board |
Re: Farmall A transmission
[ Expand ] [ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Haas on October 01, 2004 at 18:06:44 from (12.65.252.250):
In Reply to: Farmall A transmission posted by Anonymous on October 01, 2004 at 14:17:26:
You need to get a manual. It will tell you where are all the drain plugs and a lot of other valuable info. You need this especially if you are going to restore the tractor. Three places to change transmission fluid, 2 final drive housings and one transmission/differential housing. No drains on the final drives. You have to drop the pans. Get new gaskets first. Refill to bottom of fill holes. Use a 1/2 inch drive socket handle to get the plugs out. Transmission drain is under th bottom of transmission at rear of tractor. Not on the pto housing. Level plug is on left hand side behind the brake rod, at front of transmission. Transmission holds 5 quarts I believe (better check that, my memory is not the best) Don't recall the final drives, but I think about 1 quart each.
Follow Ups:
Home
| Forums
Today's Featured Article -
Ford Part Number Trivia - by Forum Participants. "Replaced by" means the part was superseded. All of my part books date back to 1964 and New Holland have changed some part numbers. They usually put the old Ford part number on the package. I was suppressed when I looked up the part number of the auxiliary drive shaft because for some reason the part number went through a radical change and it lost its "Basic Part Number". Ford part numbers follow the following rules. Most part numbers are in three parts. The middle part is called the
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|