Re: 1952 Super C Starting Problem

Posted by J in Pa on October 01, 2004 at 17:37:30 from (24.154.96.37):

In Reply to: 1952 Super C Starting Problem posted by Richflhtc01 on September 23, 2004 at 07:10:18:

rich, i had a problem with a H starter that sounds something like your problem.

i had the starter out several times and to a starter shop before a young fella found the problem.

if that starter is built the same as an H starter, there soldered lugs inside, i think for the brushs. what happened to mine was during cranking over a long period, the lugs would get hot and the solder would run or boil out.
this had happened before i got the tractor.

these lugs might look good but sometimes arent.
even with a new battery it would crank slow to the point where it would wear the battery down.

also the starter would spin just fine on the bench.but under load it would spin slow.
just my 2 cents worth. good luck and post if you find the problem.

J in Pa

Follow Ups:

Post a Followup Name: E-Mail: Subject: Comments: Optional Link URL: Link Title: Optional Image URL: Email Notification: If you check this box, email will be sent to you whenever someone replies to this message. Your email address must be entered above to receive notification. This notification will be cancelled automatically after 2 weeks.

TRACTOR PARTS	TRACTOR MANUALS

We sell tractor parts!  We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]