|
Farmall & IHC Tractors Discussion Board |
Re: Re: Re: Re: Re: Re: crankshaft farmall super c
[ Expand ] [ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Ramon from NC on September 28, 2004 at 13:26:10 from (64.102.254.33):
In Reply to: Re: Re: Re: Re: Re: crankshaft farmall super c posted by Hugh MacKay on August 17, 2003 at 15:49:39:
I'll have to resurrect this topic from the dead so hopefully Hugh and Stan can add some insights. At some point in the future, I want to rebuild my engine with the fire crater pistons. I talked to the local tractor shop, and they said they do this pretty often and use IH parts and it would be around $80 per hole (as he put it). He said you typically get up to 3 extra horse power total. The only potential downside, he stated, was that they had reports of crankshafts going bad after this upgrade but he went on to say that his mechanics never could confirm whether or not it was due to the upgrade or due to just bad crankshafts. So my questions are 1. Does 3 hp sounds like the true hp increase due to Fire Crater pistons. 2. Does the $80/hole sound reasonable (not incl labor of course) 3. Does the crankshaft issue sound plausible. 4. Is the crankshaft in a 100 the same as in a 140 or not? Thanks! Ramon
Follow Ups:
Home
| Forums
| Order Support
Today's Featured Article -
Converting from 6 Volt to 12 Volt - by Chris Pratt. It's a common problem for old machines especially when the weather starts to dip below 40 and the tractor isn't fired up as often. You are probably used to the 12 volt Diehard, charged with 200 amp alternator of your 3/4 ton that always is ready and always starts. It's this type of experience that brings about the many queries we get for 12-volt conversion kits. Since only a few kits are available (we sell kits for the
... [Read Article]
Latest Ad:
Late 50s early 60s international harvester 560 with cultivator
[More Ads]
Copyright © 1997-2026 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|