Posted by D Slater on April 03, 2009 at 07:48:40 from (71.164.43.225):
In Reply to: 362173r91 carb posted by karl f on April 02, 2009 at 22:48:18:
IH made enough changeover kits to change all tractors sold with R91 over to R92 in early 55 I think. All evidently didn't get changed because a new changeover kit shows up once in a while. Even if you have a R91 it should run and idle okay. Changes were in size of main seat or jet, discharge jet and a high speed ajusting screw and nut was added. Also a passage was pluged in bowl. Your carburetor has some change added. R 91 ones came with a plug were you have a high speed adjusting screw. The correct idle adjusting screw has a straight round section about 2/3 to half the thread size for a short distance on end then a taper to point. Main seat for a R92 carb has a .051 hole size. Main discharge jet has all three holes .055 size and tip size is .136 .
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - It's Alright Where It Is! - by Anthony West. I have a tale of a different kind to tell. Whilst rooting in the hedge bottoms this week I had cause to visit Chapel lane Farm, the home of an eccentric gentleman by the name of Austin Kendall. I had heard rumours that an old Case Model C was languishing away in the back of one of the outbuildings there. So off I went in search of what would turn out to be a very rare and unusual tractor. Mr Kendall is an excitable chap to say the least. He is amongst the last of a dying breed of farmer who
... [Read Article]
Latest Ad:
Wanted to buy model 65 massey ferguson 65 diesel
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
