Re: Building H pulling tractor

Posted by ChadS on September 20, 2004 at 07:02:43 from (66.228.96.244):

In Reply to: Building H pulling tractor posted by Howard N on September 19, 2004 at 18:58:39:

Howard, here is some info you might look into for engine options. maybe go with a 350 sleeve and piston kit. If done right, you can get a solid 50 hp out of it. Manifold and carb, a Super H-350 manifold, and a M carb. If you can find a 350 engine sitting somewhere, (c-175) grab it! The cam, and cyl head in the later versions of this engine are much better than the old H, everything interchanges. Biggest bore in a H block is 3-13/16 and still run on the block, you could go up to 4 inch bore, but that is alot of machine work, but, you can use Massey 44 pistons in it, with a stock H stroke with a 4 inch bore. Hope this helps, ChadS

Follow Ups:

• Re: Building H pulling tractor JRB IN MAINE 17:50:05 09/20/04 (0)

Post a Followup Name: E-Mail: Subject: Comments: Optional Link URL: Link Title: Optional Image URL: Email Notification: If you check this box, email will be sent to you whenever someone replies to this message. Your email address must be entered above to receive notification. This notification will be cancelled automatically after 2 weeks.

TRACTOR PARTS	TRACTOR MANUALS

We sell tractor parts!  We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]