Farmall & IHC Tractors Discussion Board |
Re: Looking at a 1586 with 4000 hours!
[ Expand ] [ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by old don on September 18, 2004 at 20:15:22 from (68.253.238.182):
In Reply to: Re: Looking at a 1586 with 4000 hours! posted by Allan in NE on September 18, 2004 at 06:15:02:
I hate to be a wet blanket on you guys but I do know the 15 fairly well and I can tell you the 15 is nothing like the bull gear tractors, it's a plantary drive tractor with wet brakes and I do know there was a problem with the brake disc compound shaving off into the rearend causing major problems usually causing bearing and gear failure in the rearend usually around 3500 hours unless the oil was changed regularly. Buyer beware.Good Luck
Follow Ups:
Home
| Forums
Today's Featured Article -
The Nuts and Bolts of Fasteners - Part 2 - by Curtis Von Fange. In our previous article we discussed capscrews, bolts, and nuts along with their relative hardness and thread sizes. In this segment we will finish up on our fasteners and then work with ways to keep them from loosening up in the field. Capscrews, bolts and nuts are not the only means of holding two parts together. When dealing with thinner metals like sheet tin, a long bolt and
... [Read Article]
Latest Ad:
18-32 Case Cross Motor
[More Ads]
Copyright © 1997-2025 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|