Re: H toolbox decal

Posted by Wardner on September 17, 2004 at 12:35:10 from (64.136.49.228):

In Reply to: H toolbox decal posted by Gordon on September 16, 2004 at 20:08:37:

The surface underneath the decal is struck with a flatening die so that the decal sticks better. This would seem to indicate that the factory placed its own decal on that spot. If you have an original lid that hasn't been sandblasted or heavily rusted, you may be able to discern the imprint of the die.

I haven't seen an original decal but I doubt if they were dealer produced and applied.

Mark Mathis in Cairo, MO reproduces the tool box. His fabricator strikes the lid with the same die. Mark may have the right decal.

Follow Ups:

• Re: H toolbox decal Gordon 06:44:26 09/18/04 (0)
• Re: H toolbox decal brianh 13:54:30 09/17/04 (2)
  • Re: H toolbox decal Wardner 14:54:17 09/17/04 (1)
    • Re: H toolbox decal brianh 19:31:06 09/17/04 (0)

Post a Followup Name: E-Mail: Subject: Comments: Optional Link URL: Link Title: Optional Image URL: Email Notification: If you check this box, email will be sent to you whenever someone replies to this message. Your email address must be entered above to receive notification. This notification will be cancelled automatically after 2 weeks.

TRACTOR PARTS	TRACTOR MANUALS

We sell tractor parts!  We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]