|
Farmall & IHC Tractors Discussion Board |
Farmall H Magneto problems???
[ Expand ] [ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by John in Ct. on September 16, 2004 at 20:32:27 from (192.233.162.155):
My Farmall H won't run. The problem started with my removing the magneto drive to replace the gasket. I ended up loosing the timing marks on the Magneto drive. I was able (By LOTS of trial and error)to get the magneto drive to where I think it belongs. The magneto clicks before the #1 terminal on the distriburor cap when the #1 cylinder is at TDC and the pully is at the first mark. My problem is that my Farmall H now won't run. We even put some gas in the cylinders, no luck so we think it must be spark. I dressed the points, replaced the cap and roter. I think it has a good spark then a weak spark, I am not sure if it is inside of the cap orin the magneto itself. It was hard for me to tell. It was necessary for me to trip the magneto a lot( Not hooked up, maybe 30 complete revolutions) so I could figure out timing it. Could I have messed it up? Also, the kill switch screw turned while hooking the wire back up, could this be the problem? Thanks!!
Follow Ups:
Home
| Forums
| Order Support
Today's Featured Article -
Talk of the Town: Removin Broken Bolts - by Staff. Another great discussion from the Tool Talk Discussion Forum. The discussion started out with the following post: " How would I remove a bolt thats broken off in a piece of metal and I want to save the treads in the metal and then put in a new bolt. "
... [Read Article]
Latest Ad:
Late 50s early 60s international harvester 560 with cultivator
[More Ads]
Copyright © 1997-2026 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|