Re: I need a foolproof head seal on H

Posted by Dale L on September 04, 2004 at 15:35:11 from (69.21.224.141):

In Reply to: I need a foolproof head seal on H posted by Red Dread on September 04, 2004 at 12:08:53:

I was just about to put the head on my H when my brother-in-law noticed pittiing on the block where the head water ports match the block. After looking at the old gaasket you could see where the gasket was leaking.[That is probably why the no. 3 cylinder was froze up]I just got the block back from the machine shop they had to take of .040. The head gasket is .100 thick it only leaves me with .060 clearance. Now I notice the studs are not the same length,Five are longer than the rest. But that's a subject for another posting. that might be the problem. Good luck

Follow Ups:

Post a Followup Name: E-Mail: Subject: Comments: Optional Link URL: Link Title: Optional Image URL: Email Notification: If you check this box, email will be sent to you whenever someone replies to this message. Your email address must be entered above to receive notification. This notification will be cancelled automatically after 2 weeks.

TRACTOR PARTS	TRACTOR MANUALS

We sell tractor parts!  We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]