Farmall & IHC Tractors Discussion Board |
Re: IH 66 series tractor questions
[ Expand ] [ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Hugh MacKay on August 31, 2004 at 14:16:14 from (209.226.106.96):
In Reply to: Re: IH 66 series tractor questions posted by Matt K. on August 31, 2004 at 06:58:08:
Matt: They were not a mechanical gear lock like most smaller tractors. My understanding is, it is a wet clutch pack much like IPTO. I had a Deere about the same weight, less power, (about 100 hp)and the diff lock was very effective. Again it was the same type. I always called my 1066 a costly learning experience. I needed the PTO horse power, at time of purchase I was not too concerned about drawbar hp. Problem comes when you try to put that much horse power on the drawbar it takes rubber and lot of it on our eastern soils. Dealer delivered the tractor on singles with tires loaded, then came a 25' cultivator and 20' disk with 20" blades. During tillage tractor would leave wheel tracks, enough it interfered with seeding. In the first 1,000 hours the 1066 ruined those rear tires. The tires had bulges large enough you could use high gear. IH dealer brought in Goodyear they replaced the tires, and I bought a second set and the dual rims. I did not put the chloride back in. Cured the tracks in the tilled fields, plus I had better traction with duals than I ever got from the singles with chloride, on tillage work, remember that. It will not hold true on hard roads or ground. I then had a new problem on tillage work. Load one of those tractors with duals pulling, and it wants to go straight ahead. I started getting front end breakage, spindles, etc. My opinion tractors that size should be 4x4. So much easier on the brakes, if your not using them for turning. I have driven a few tractors since rear duals and 4x4 under heavy tillage loads. Definately the way to buy a 100 hp plus tractor. I will add this though, if its tillage work you do go articulated.
Follow Ups:
Home
| Forums
Today's Featured Article -
Talk of the Town: What's in Your Tractor's Toolbox? - by Staff. This recent discussion on the Tractor Talk discussion board here at the on-line magazine drew so much response and proved to be so interesting that we wanted to share it with you here. The names of the people participating in the discussion have been left out to "protect the innocent" (to quote a once-popular television series).
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
Copyright © 1997-2025 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|