|
Farmall & IHC Tractors Discussion Board |
Re: tractor shopping: 454 vs 464
[ Expand ] [ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by JB2 on August 30, 2004 at 17:09:26 from (24.157.143.220):
In Reply to: tractor shopping: 454 vs 464 posted by genep on August 30, 2004 at 15:29:34:
Hi, both basically the same tractor but 464 has 4 cylinder D206 vs 3 cylinder D179 engine therefore the 464 has slightly more HP. The D206 is also in 584 and has same pistons, sleeves and rods as the 6 cylinder D310. The D179 has same cylinders etc as 4 cylinder D239 in 574 and 684. In my part of the country the 464s were rare as most farmers chose the 574 with the D239 which could be cranked up close to 65 HP with adjusting the injector pump. From archives: Hi, my dad, then my brother have owned the same 454D for over 30 years. The hour meter quit several years ago at about 5000 hrs. but probably in excess of 10,000 hrs on it. Great utility tractor. German Diesel runs for ever with minimal maintance. Had diesel go into the crankcase oil twice caused by an $8 oil seal on the Bosch injector pump. As someone else mentioned the parking brake if accidently left on and the tractor driven the transmission/hydraulic system will be clogged with brake lining. Also the hydraulic brakes can be a problem when they are old and the seals start to leak and air gets in the brake lines. Also check to see if power steering unit is leaking oil from under the dash down by the clutch and brake pedals. My brother's has leaked a little for 10 years now but not enough to fix yet. Another caution is be careful connecting to other hydraulic cylinders make sure that they have the proper IH Hytran hydraulic oil in them. Therefore choose the one that you feel most comfortable with. My 2 cents JB2
Follow Ups:
Home
| Forums
| Order Support
Today's Featured Article -
Hydraulics - Cylinder Anatomy - by Curtis von Fange. Let�s make one more addition to our series on hydraulics. I�ve noticed a few questions in the comment section that could pertain to hydraulic cylinders so I thought we could take a short look at this real workhorse of the circuit. Cylinders are the reason for the hydraulic circuit. They take the fluid power delivered from the pump and magically change it into mechanical power. There are many types of cylinders that one might run across on a farm scenario. Each one could take a chapter in
... [Read Article]
Latest Ad:
1958 FORD RARE 4x4 801 TRACTOR, ELENCO/FRONT DRIVE, FRONTLOADER AND WEIGHTED REAR WHEELS, FIVE SPEED, LIVE PTO, GAS ENGINE, NEW REAR WHEELS AND TIRES, ENGINE RUNS.
[More Ads]
Copyright © 1997-2026 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|