|
Farmall & IHC Tractors Discussion Board |
Re: IH 474
[ Expand ] [ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by JB on August 17, 2004 at 20:04:49 from (24.157.143.220):
In Reply to: IH 474 posted by Steve Ga. on August 17, 2004 at 18:10:47:
Hi Steve, this is from archives: The 474 is an English built tractor that is very similar to the 574. The 474 uses the Neuss built D206 four cylinder diesel engine. They were rated at approx. 52 pto horsepower and were available in an 8 speed gear drive or a hydrostatic version. Both versions were sold in Canada but I don't think IH ever sold them in the U.S.They date from about 1974 to 1977. Don Now my 2 cents, my brother has a 454, 495 and 684 and the only difference from 474 is engine, rear wheel sizes and heavier 3pt and front end. The 454 & 495 use a D179 and 684 uses D239 where the 474 uses a D206. These are excellent Diesel engines. Run a long time with very low maintance. The achilles heel of these tractors is the parking brake. There is an idiot light on the dash to indicate the parking brake is on but to often it is burned out and tractor is driven with parking brake engaged. The parking brake is a band inside the transmission and if it is driven with it engaged it will leave bits of groundup parking brake band inside the transmission. This would not be so bad but the transmission is also lubed and cooled by the hydraulic oil. Eventually these bit of parking brake band will clog the hydraulic system. Check parking brake for holding while engaged. If it does not hold then it probably has been through the above treatment. P.S. newer X95 series have flashing amber light on dash for parking brake. My 2 cents JB
Follow Ups:
Home
| Forums
| Order Support
Today's Featured Article -
Fabricating Sidesheets - by Chris Pratt. The easiest and best first-time project for wanna-be sheet-metal workers like myself is flat or nearly flat metal cut and drilled to be a tractor's sidesheet. A sidesheet is sheetmetal to cover either the engine as in the case of early Oliver's, Massey-Harris' and many crawlers or the wiring and electrical components as in the case of the Massey-Harris Pony, Allis Chalmers' D Series (D-14, D-15, D-12, D-10, D-17, and D-19). The need for fabricating becomes obvious when you go to buy any of these
... [Read Article]
Latest Ad:
For sale Farmall super A tractor is complete and has just been setting for awhile,it was running when pulled out of the barn,shouldn’t take to much to get it going asking 1100.00
[More Ads]
Copyright © 1997-2026 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|